This is something that was a bit of a mystery to me in my early years.

days.

I would listen to people talk about the grain on the green and how

the ball would go fast if the bean leaned towards the hole

and since the ball did not reach the hole if one put

upstream unless this factor has been taken into account.

Well, here’s a bit about the grain in case you, like me, find this

subject a bit of a mystery.

When grass grows, it grows in a particular direction.

The grass on the putting greens is a special type of grass and lies flat on the surface.

There are bent weeds that lie flat because it is the nature of

the grass bends at ground level and grows horizontally, hence the

name.

There are other types of grass that are cut very short and tend to grow a bit taller.

horizontally.

Luckily all the grass grows in the same direction.

If you can imagine the grass a bit longer but still horizontal,

you can see that if you are lying in the direction of the post, that

there will be very little resistance as the ball rolls.

However, if it is growing towards you and away from the direction

of the put, each blade of grass acts as a product, so to speak, to stop

the ball rolling

Therefore, the ball will be held a little and not

roll so far

This producing effect is called the grain.

It represents the direction in which the grass grows.

One way to determine which direction it is growing is to look at the

fat.

If it has a slight sheen to it or looks clear, it’s moving away from you.

If you hit a ball along this path, it’s called pimple hitting.

If it is dark, it is because you are looking at the tips of the

grass and the dark part between the blades of grass and the ground.

This means that the grass is growing towards you.

Hitting a put along this path is called hitting upstream.

Certain things determine which way the grass will grow,

and these can be taken into account if in doubt.

Most of the grasses will grow towards the nearest water.

They will also grow in the direction of drainage,

They often grow towards the setting sun.

RELATED ARTICLES

How is RoHS compliance ensured in Assembled circuit board?

RoHS compliance ensured in Assembled circuit board Ensuring RoHS (Restriction of Hazardous Substances) compliance in assembled circuit boards is a critical aspect of modern electronics manufacturing, reflecting a commitment to environmental responsibility, consumer safety, and regulatory compliance. RoHS directives restrict the use of certain hazardous…

Leave a Reply

Your email address will not be published. Required fields are marked *